Monetary discount applied by retailer representative at the time of contract execution. Minimum purchase of 2 units required to qualify for promotional offer. Cannot be combined with prior purchases, offers, or coupons. Restrictions and conditions apply, see your local representative for details. * Renewal by Andersen of British Columbia is a locally owned and operated Canadian affiliate of Renewal by Andersen. I'd give Corey and his crew a 10 out of 10 for their service.The 20 year warranty on the glass and Fibrex portion of the windows and the 10 year warranty on the remainder of the hardware was much appreciated seeing as one of our neighbours who went with a different company three years ago had issues within 2 years but were only covered for 1 year. The installed windows and doors look very good and make our home more comfortable. The crew cleaned up thoroughly after the installation work was completed. Corey and his crew were very professional and respectful of our concerns about physical distancing, etc. While it took slightly longer than expected for the job to be completed due to some Covid-19 supply chain issues (who hasn't run into those in the last couple of years?), the job was completed and we are very happy with the results. Jason gave us multiple options to choose from that would fit into our strata's requirements and was straightforward about the time it would take to manufacture the windows and doors. If finish gets on the exterior side, quickly wipe down with a cloth before the finish cures.Īpplying Stain (for stained or natural finish)Īpplying Paint (Use the same primer and paint that you use to finish the interior and/or exterior of your windows or patio doors).īe sure to consult with your local paint/finish store representative or professional to help address your specific finishing needs.We had our windows and patio doors replaced by Renewal by Andersen. Be careful not to get the finish on the exterior side of the grille. Lay the grille on a flat, covered surface and apply the finish with a spray or brush application, per the recommendations of your local paint store representative or professional. Remove all sanding dust with a tack cloth before applying the finish. If the interior side of the grille is primed or unfinished, lightly sand with the grain of the wood using 180-grit or finer sandpaper to remove any rough surfaces and to help ensure a more consistent stain finish. ![]() The exterior side of the grille already matches the exterior cladding and requires no finishing. Remove the wood grilles between-the-glass. If you choose to paint one side of the grille and stain the other, use removable painter's tape, with a light adhesive, to mask off the grille as you're applying a specific finish to one side only.įinishing s nap-in wood grilles between-the-glass ![]() Be sure to finish the grille ends to seal and help protect the wood. For a painted finish, use the same primer and paint that you use to finish the interior and/or exterior of your windows or patio doors. For a stained or natural finish, use the same steps as mentioned for the stained interior finish of your windows or patio doors. Some grilles allow for different interior and exterior finishes (such as paint on the outside surface and stain on the inside surface). The side that slides over the brass-colored tack will face the exterior the longer, tapered side will face the interior. Removable roomside grilles should be removed before finishing (to prevent scratching the glass) and sanded lightly with 180-grit or finer finishing sandpaper.īefore you begin finishing, look at the grille to determine which side will face the room. ![]() ![]() Finishing removable roomside wood grilles
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |